Matthew Bond
New Member
Hey guys,
I have 4 pivot charts (clustered columns) that are all linked to several slicers. The slicers are all connected with "PivotTable Connections". On each of these charts, I'm displaying a target line, which I've formatted as a Line Chart. Any time I use the slicers the target line gets formatted as clustered column, and I can't figure out a way of preventing that.
Any help you guys can offer is very much appreciated. I've attached the workbook in question. The charts I'm referencing are under the "New Hire Status" section.
I have 4 pivot charts (clustered columns) that are all linked to several slicers. The slicers are all connected with "PivotTable Connections". On each of these charts, I'm displaying a target line, which I've formatted as a Line Chart. Any time I use the slicers the target line gets formatted as clustered column, and I can't figure out a way of preventing that.
Any help you guys can offer is very much appreciated. I've attached the workbook in question. The charts I'm referencing are under the "New Hire Status" section.